Made by Cement Australia
Sand and paving · Paving and mixes
Dried Sand 20kg
Washed, dried sand with no additives for paver joints, mortar, render and concrete. Meets AS3700.
Comes on pallets of 48 × 20kg bags.
1 bag (less than a pallet).
Lead time: Approx. 1 to 2 working days
Code: 200842128
Available to order from Allmat. Click and collect or delivered across Adelaide.
About Dried Sand 20kg
A washed and factory dried sand with less clay and fewer impurities, and no cement additives. It meets AS3700 for bricklaying sand.
Sweep it into paver joints, or blend it with cement and aggregate for consistent mortar and concrete.
- Standard
- Meets AS3700 for bricklaying sand
- Additives
- None
- Washed
- Less clay and fewer impurities
- Brick pavers
- About 3.5m² per bag at 3mm joints
- 400mm pavers
- About 12m² per bag at 3mm joints
Concrete and render ratios with the bags of cement per m3 are in our mix ratio table; mortar mixes are on the mortar calculator.
Best for
- Paver joints
- Mortar and render mixes
- Concrete and grout mixes
- Backfill, landscaping and artificial lawn
Not for
- Gaps over 3mm between pavers: Sand & Cement suits those
Storage & safety
Store the bags dry and off the ground. Each 20kg bag is a two-person lift.
- Fine sand dust carries crystalline silica, so wear goggles and gloves and keep from breathing it.
Documents
The manufacturer's own sheets. Open one to read it on the page, share it or download the PDF.
- Dried Sand safety data sheet (SDS)7 pages
- Dried Sand data sheet2 pages
Dried Sand questions
Backfill and trench fill, artificial lawn and landscaping, potting mix blends, grease traps and BBQ trays, and animal litter.
Sources and guidance
The product information on this page comes from Cement Australia's published product data sheets, safety data sheets and website (see Documents above). It is general guidance only. Other manufacturers may give different advice for their own products, so always follow the instructions on the bag and the product's data sheet. Structural work, such as footings for buildings, must follow your engineer's design and the relevant Australian Standards.
You may also need
Often ordered with this product. Use + Add to pick the option and quantity and put it on the same quote.
Gap Sand 20kg
Paver joint sand that binds when dry and helps keep weeds and insects out, for gaps up to 3mm.
Sand & Cement 20kg
Pre-blended sand and cement mortar for shower bases, toilet pans, paver joints and repairs.