Hobson performance data
Wafer Head Tek Screw 10-16 x 22, Zinc Yellow: Performance Data
A three-page DRiLLX performance data sheet for one screw: the 10 gauge, 16 TPI, 22mm wafer head Phillips self drilling screw (part T9PMYWP1016022) in zinc yellow passivate. It covers dimensions, pullout values in sheet steel, mechanical properties, a drill point test and installation.
What this covers
- Dimensions
- Pullout values
- Mechanical properties
- Drill point test
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Part T9PMYWP1016022: 10 gauge, 16 TPI, 22mm long, 9mm wafer head, Phillips #2 drive. C1022 hardened steel, zinc yellow passivate finish.
- Listed uses: sheds, and fencing and gates.
- Working pullout load: 350N in 0.7mm G2 sheet, 650N in 1.1mm G2, 1,400N in 1.5mm G550, 1,950N in 2.0mm G450 and 2,500N in 2.5mm G450 steel. Working loads already include a factor of safety of 2.5 for steel; mean and characteristic loads are also listed. All values are laboratory results.
- Characteristic shear strength 5,750N and characteristic tensile strength 9,550N (mean 7,100N and 11,800N); torsional strength 6.9Nm.
- Drill point test: through 2.0mm G450 steel under an 18kg load at 2,200RPM in no more than 4 seconds (3 seconds average).
- Install with a cordless screwdriver set between 2,200 and 3,000RPM, with consistently firm pressure while it drills. Do not over-tighten, and impact drivers are not recommended.
Who it helps: Shed, fence and gate builders, and staff checking the figures for this screw.
Share this document
Email it to yourself
Loading…
Related
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.