Hobson performance data
Metal SDS Undercut Head 410 Stainless Phillips Screw 10-16: Performance Data
Hobson's three-page DRiLLX product data sheet for the Metal SDS undercut 410 stainless Phillips screw, 10 gauge. It covers the description, applications, dimensions, pull-out values, mechanical properties and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Parts T41MSDP1016012, 018 and 022: 10-16 x 12, 18 and 22mm, #2 Phillips.
- Martensitic 410 stainless steel. The undercut head sits flush in thin metal plates such as hinges or brackets without bottoming out.
- For brackets, hinges into metal without pre-drilling, and thin metal plates where a flush finish matters.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 200N in 0.5mm G2, 1,550N in 1.5mm G450, 2,500N in 2.9mm G450. Laboratory values; actual loads depend on the base material.
- Use a #2 Phillips drive bit in a cordless screw gun at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Installers fixing hinges and brackets where a flush head matters.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.