Hobson performance data
Metal SDS Pan Head Screw 6-20 x 12, Zinc Yellow: Performance Data
Hobson's two-page DRiLLX product data sheet for the Metal SDS pan head screw, 6-20 x 12mm, zinc yellow passivate, for light metal to metal fixing. It covers applications, pull-out values, a drill point test, mechanical properties, dimensions and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Part T9PMYPP0620012: 6-20 x 12mm, #2 Phillips pan head, packed 1,000.
- For internal wall cladding to light gauge framing, wall cladding, fencing and gates, signs, and general purpose lightweight internal fastening.
- C1022 hardened steel with a zinc yellow passivate finish.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 200N in 0.5mm G550, 450N in 1.2mm G2, 800N in 1.5mm G550. Laboratory values; actual loads depend on the base material.
- Use a #2 Phillips drive bit in a cordless screw gun at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders doing light internal fixing to thin steel framing.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.