Hobson performance data
Metal SDS Flanged Hex Head Screw 10-16 x 16, Class 3: Performance Data
Hobson's two-page DRiLLX product data sheet for the Metal SDS flanged hex head screw, 10-16 x 16mm, Class 3. It covers applications, pull-out values, a drill point test, mechanical properties, dimensions and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Part T9PM3FH1016016: 10-16 x 16mm, 5/16 inch hex head, packed 1,000.
- For metal to metal fixing: wall cladding, sheds, fencing and gates, signage, and hinges into metal posts, gates and doors.
- C1022 hardened steel with a Class 3 finish.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 350N in 0.7mm G2, 1,450N in 1.5mm G550, 2,500N in 2.5mm G450. Laboratory values; actual loads depend on the base material.
- Drill test: through 2.0mm G450 in no more than 4 seconds at 2,200 RPM with 18kg load.
- Use a 5/16 inch hex drive bit in a cordless screw gun at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders and fabricators doing general metal to metal fixing.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.