Hobson performance data
Metal SDS Flanged 550 Stainless Hex Head Screw 12-14: Performance Data
Hobson's three-page DRiLLX product data sheet for the Metal SDS flanged 550 stainless hex head screw, 12 gauge. It covers the material, applications, dimensions, pull-out values, mechanical properties and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Parts T55MSFH1214025, 035 and 045: 12-14 x 25, 35 and 45mm, 5/16 inch hex head.
- Made from 550 stainless: a high-hardness martensitic stainless steel that drills well, with extra chromium for corrosion resistance the sheet rates as equivalent to 304.
- For fastening exterior decorative steel sheets to steel channels and for stainless steel facades. The sheet says it replaces spot welding of stainless steel.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 150N in 0.5mm G2, 1,450N in 1.5mm G450, 2,250N in 2.9mm G450. Laboratory values; actual loads depend on the base material.
- Use a 5/16 inch hex drive bit in a cordless screw gun at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Facade and sheet metal installers working with stainless steel.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.