Hobson performance data
Metal SDS Flanged Hex Head Screw 8-18 x 12, Zinc Yellow: Performance Data
Hobson's two-page DRiLLX product data sheet for the Metal SDS flanged hex head screw, 8-18 x 12mm, with a zinc yellow passivate finish. It covers applications, pull-out values, a drill point test, mechanical properties, dimensions and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Part T9PMYFH0818012: 8-18 x 12mm, 1/4 inch hex head, packed 1,000.
- For metal to metal fixing: wall cladding, sheds, fencing, signage, and hinges into metal posts, gates and doors.
- C1022 hardened steel with a zinc yellow passivate finish.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 300N in 0.7mm G2, 1,250N in 1.5mm G550, 2,200N in 2.5mm G450. Laboratory values; actual loads depend on the base material.
- Drill test: through 1.5mm G550 in no more than 4.5 seconds at 2,200 RPM with 18kg load.
- Use a 1/4 inch hex drive bit in a cordless screw gun at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders and fabricators doing light metal to metal fixing.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.