Hobson performance data
Metal SDS Hex Head with Seal 8-18 x 12, Class 4: Performance Data
Hobson's two-page DRiLLX product data sheet for the Metal SDS flanged hex head screw with seal, 8-18 x 12mm, Class 4. It covers applications, pull-out values, a drill point test, mechanical properties, dimensions and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Mechanical properties
- Dimensions and part numbers
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Part T9PM4SH0818012: 8-18 x 12mm, 1/4 inch hex head with seal, packed 1,000.
- For metal to metal fixing: wall cladding, sheds, pergolas, roofing sheet and valley fixing.
- C1022 hardened steel with a Class 4 finish.
- Working pull-out load from the steel it is fixed into, safety factor 2.5 already included: 300N in 0.7mm G2, 1,250N in 1.5mm G550, 2,200N in 2.5mm G450. Laboratory values; actual loads depend on the base material.
- Use a 1/4 inch hex drive bit and a cordless screw gun at 2,200 to 3,000 RPM and firm, steady pressure while it drills. Do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders fixing flashings, valleys and light cladding to steel.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.