Hobson performance data
8g Countersunk Metal Tek Screw 8-18 x 25, Zinc Yellow: Performance Data
Hobson's two-page DRiLLX performance data sheet for the 8 gauge, 18 TPI countersunk metal self-drilling screw, 25mm long, in zinc yellow passivate (part T9PMYCP0818025). It covers applications, pull-out values, the drill point test, mechanical properties, dimensions and installation.
What this covers
- Applications
- Material and finish
- Pull-out values
- Drill point test
- Mechanical properties
- Sizes
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- For timber cladding, fencing and gates, signage and hinges into metal posts.
- C1022 hardened steel, zinc yellow passivate finish. One size: 8-18 x 25, Phillips #2 drive, packs of 1,000.
- Pull-out working load: 300N in 0.7mm G2 plate, 1,250N in 1.5mm G550 and 2,200N in 2.5mm G450. The working loads already include factors of safety and come from laboratory tests.
- Drill point test: drills 1.5mm G450 plate in 3 seconds on average (4 seconds maximum) at 2,200 RPM under an 18kg load.
- Install with a cordless screwdriver set at 2,200 to 3,000 RPM, with firm, steady pressure while it drills. Do not over-tighten, and impact drivers are not recommended.
Who it helps: Builders and fencers fixing cladding, gates or hinges to steel.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.