Hobson performance data
BDX Metal SDS Wafer Head 10-16 x 16 to 50mm: Performance Data
Hobson's three-page performance data sheet for the BDX metal SDS wafer head screw, part prefix T9PM9WP1016. It covers sizes, pullout values, mechanical properties, a drill point test and installation.
What this covers
- Applications
- Material and finish
- Sizes and dimensions
- Pullout values
- Mechanical properties
- Drill point test
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- 10 gauge, 16 TPI, lengths 16, 22, 30, 40 and 50mm, wafer head 9mm across and 2mm high, Phillips #2 drive.
- C1022 hardened steel with the X9 ProteXion coating, which the sheet rates as suitable for ISO 9223 category 4 environments.
- Uses: metal to metal fixing, wall cladding, sheds, fencing and gates, conduit and pipe saddles.
- Working pullout load: 400N in G2 steel 0.8mm, 2,400N in G450 2.0mm and 3,000N in G2 3.0mm. The 2.5 factor of safety for steel is already included; the mean and characteristic loads beside them are test values. All values come from laboratory tests, and real pullout can differ with the base material.
- Drill point test: under a 24kg load at 2,200 RPM it drills 2.5mm G450 plate in no more than 2.5 seconds on average (3 seconds at most for any one screw).
- Drive with a cordless screw gun at 2,200 to 3,000 RPM using a Phillips #2 bit, with firm, steady pressure, and do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders, fabricators and roofers choosing a self-drilling screw for steel, and staff checking sizes or pullout figures.
Share this document
Email it to yourself
Loading…
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.