Hobson performance data
Metal SDS Flanged Hex Head 12-14 x 20 to 45mm: Performance Data
Hobson's three-page performance data sheet for the metal SDS flanged hex head screw, part prefix T9PM9FH1214. It covers sizes, pullout values, mechanical properties, a drill point test and installation.
What this covers
- Applications
- Material and finish
- Sizes and dimensions
- Pullout values
- Mechanical properties
- Drill point test
- Installation
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- 12 gauge, 14 TPI, lengths 20, 25, 30, 35 and 45mm, flanged hex head 14mm across with a 5/16 inch drive.
- C1022 hardened steel with the X9 ProteXion coating, which the sheet rates as suitable for ISO 9223 category 4 environments.
- Uses: metal to metal fixing, hinges into metal posts, gates and doors, wall cladding, sheds, fencing and gates, and stitching roof flashing.
- Working pullout load: 560N in G2 steel 1.1mm, 1,850N in G450 1.9mm and 3,840N in G450 3.8mm. The 2.5 factor of safety for steel is already included; the characteristic loads beside them are test values. All values come from laboratory tests, and real pullout can differ with the base material.
- Drill point test: under a 18kg load at 2,200 RPM it drills 1.9mm G450 plate in no more than 3 seconds on average (3.5 seconds at most for any one screw).
- Drive with a cordless screw gun at 2,200 to 3,000 RPM using a hex drive bit, with firm, steady pressure, and do not over-tighten. Impact drivers are not recommended.
Who it helps: Builders, fabricators and roofers choosing a self-drilling screw for steel, and staff checking sizes or pullout figures.
Share this document
Email it to yourself
Loading…
Related
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.