Hobson performance data
Needle Point Plasterboard Bugle Screws, Coarse Thread 6-9: Performance Data
Hobson's two-page performance data for DRiLLX needle point plasterboard bugle screws with coarse thread, 6 gauge, 9 TPI (part T9PCLBP0609). They fix plasterboard or OSB to wall studs or ceilings, and plasterboard wall lining to timber.
What this covers
- Applications
- Pull-out values
- Mechanical properties
- Sizes
- Installation
For Plasterboard Screw.
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Lengths 25mm, 32mm and 41mm, 6 gauge 9 TPI, 8.2mm bugle head, Phillips #2 drive.
- C1022 hardened steel, black phosphate finish.
- Working pull-out loads (safety factors already included): 1,400N in F7 pine and 2,050N in hardwood at 30mm embedment; 250N in 0.55mm G550 steel. Lab results.
- Install with a cordless screwdriver at 3,000 to 4,500rpm, firm steady pressure, and do not over-tighten. Impact drivers are not recommended.
- Recommended Phillips #2 bits: TXDIPPHS20050, TXDIPPHS20075, TXDIPPHS20100 and TXDIPPHS20150.
Who it helps: Plasterers and builders lining walls and ceilings on timber framing.
Share this document
Email it to yourself
Loading…
Related
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.