Hobson data sheet
Power-TX EZBIT Countersink Tool Kit for Decking: Data Sheet
A one-page data sheet for the Power-TX EZBIT countersink tool kit, part prefix TXDEZPK. It pre-drills and countersinks in one step for decking and general timber work, and the sheet lists the four gauge sizes and how to set and use the tool.
What this covers
- Applications
- Sizes
- Features
- Installation guide
Key things to remember
The essentials from this document in plain words. Check the full document before you rely on a figure.
- Four kits to suit 8, 10, 12 and 14 gauge screws, with 3.2, 3.6, 4.0 and 4.8mm HSS drill bits.
- For decking and general timber work, in softwood and hardwood. It gives a chip-free countersunk pilot hole and helps stop the timber splitting.
- A free-spinning collar sets the depth against the timber face; the height is adjustable for different hole and countersink depths. Maximum drill depth 45mm.
- 1/4 inch drive. A hex key and a replacement drill bit come in the pack.
- Set the collar on a scrap piece of timber first, drill until the plastic sleeve sits fully on the timber, then drive the screw with a cordless driver at no more than 1,500 RPM. Impact drivers are not recommended.
Who it helps: Deck builders and carpenters fixing hardwood or softwood boards with countersunk screws.
Share this document
Email it to yourself
Loading…
Related
This document is published by Hobson Engineering, who supply this range to us. We show it here in full so you can read it next to the product; the summary above is ours. Read it on this page or download the PDF. For the most current version, ask us.